Check a USDT address before you send

Most lost USDT is sent to a mistyped address or the wrong network. Paste an address below to see which network it belongs to and whether its format is valid.

Magnifying glass over a crypto coin, checking a USDT wallet address before sending

A USDT address tells you a lot before you send anything: which family of networks it belongs to, and whether it was typed or copied correctly. This checker reads the format, verifies the built-in checksum where the network has one (Tron, TON), and points you to the right block explorer, all inside your browser.

USDT address checker

TRC20 · ERC20 · TON · SOL

Checked locally in your browser. Nothing is sent to our servers.

What the checker tests

NetworkAddress looks likeWhat we verify
Tron (TRC20)Starts with T, 34 characters, Base58Base58 decoding, 0x41 prefix and the double-SHA-256 checksum
Ethereum and EVM chains (ERC20, BEP20, Polygon, Arbitrum, Avalanche)0x + 40 hex charactersLength and characters; mixed-case checksum is not enforced
TON48 characters starting with UQ or EQ (or raw 0:… form)Base64 decoding and CRC16 checksum
Solana32–44 Base58 charactersDecodes to a 32-byte public key

A checksum is a few extra bytes calculated from the rest of the address. If a single character is mistyped, the checksum almost never matches, so the checker can tell you "this address was corrupted" even though it can't tell you who owns it.

A safe sending routine

Every experienced USDT user follows some version of this checklist. It takes a minute and prevents most losses.

  1. Get the address from the source. Ask the receiver to copy it from their wallet or exchange deposit page, not from a screenshot or an old chat.
  2. Confirm the network in words. "TRC20 on Tron" or "BEP20 on BNB Chain", explicitly. Exchanges show the network next to the deposit address.
  3. Run it through the checker. Make sure the detected network matches what they told you.
  4. Compare the full string. Check at least the first six and last six characters against the original. Better: all of them.
  5. Send a test. Send a small amount, confirm it arrived on the explorer and with the receiver, then send the rest.
  6. Save trusted addresses. Use your wallet's or exchange's address book (whitelist) so you never paste a fresh address for repeat transfers.

For the full process, including fees and confirmation times, see how to send USDT.

Address poisoning: the scam that beats careful people

Address poisoning is now one of the most common ways people lose USDT, especially on Tron and Ethereum. It works like this:

  • A scammer generates an address whose first and last few characters match an address you've used.
  • They send you a tiny USDT transfer or a zero-value token transfer from it, so it appears in your transaction history.
  • Next time you copy "the usual address" from your history, you copy theirs.

The checker can't detect poisoning, because the scammer's address is perfectly valid. Your defences are habits: copy from an address book, never from history; compare the whole address; and be suspicious of tiny unexpected incoming transfers. More scam patterns in our USDT scams guide.

Letter tiles spelling scam, a reminder that a valid USDT address can still belong to a fraudster
A valid format says nothing about who controls the address.

Looking up an address on a block explorer

After the check, the tool links to a public explorer for that network: Tronscan for Tron, Etherscan for Ethereum-format addresses, Tonviewer for TON and Solscan for Solana. On the explorer you can see:

  • The balance and token holdings, including whether the address holds USDT at all.
  • Transaction history, useful for confirming that a payment arrived and how many confirmations it has.
  • Labels and warnings. Explorers often tag exchange wallets, known scam addresses or blacklisted addresses.

For EVM addresses, remember the Etherscan link only shows Ethereum. To check BNB Chain or Polygon activity you need that chain's explorer.

Network-specific details that catch people out

Each network has small quirks that matter as much as the address itself.

Tron (TRC20). Sending USDT on Tron needs "energy" and "bandwidth". If your wallet has none, the network burns TRX from your balance instead: roughly 6–7 TRX for a normal transfer and about 13 TRX if the receiving address has never held USDT. No TRX in the wallet means the transfer simply fails, a common surprise for people who only hold USDT. Our TRC20 guide explains energy rental and staking.

Ethereum and EVM chains. You pay gas in the chain's own coin: ETH on Ethereum and Arbitrum, BNB on BNB Chain, POL on Polygon, AVAX on Avalanche. A wallet holding only USDT can't send it. Also note that the USDT contract on BNB Chain is a bridged token with 18 decimals, and on Polygon and Arbitrum it is now USDT0. Wallets handle this automatically, but it matters if you add tokens manually.

TON. Exchanges often give one shared deposit address plus a memo or comment that identifies your account. If you send without the memo, the funds reach the exchange but not your account, and recovery takes a support ticket. Your wallet also needs a little TON for fees. See USDT on TON.

Solana. Receiving USDT for the first time requires a small token account, funded with a one-time deposit of about 0.0015 SOL that is refundable if the account is closed. Most wallets create it automatically when you send to a fresh address, and the sender pays.

Exchange deposit addresses. Some exchanges rotate deposit addresses or change supported networks. Always copy a fresh address from the deposit page before each large transfer, and check the network list shown there.

What to do if you sent to the wrong place

SituationCan it be recovered?What to do
Typo, address valid but belongs to nobody you knowAlmost neverNothing can reverse a confirmed transfer; report if it's a scam
Right exchange, wrong networkSometimesContact the exchange's official support with the transaction hash; recovery may cost a fee
Your own wallet, other EVM chainUsually yesImport the same seed phrase into a wallet that supports that chain
Sent to a scammerPossibly frozenReport to police and the platform fast; Tether can freeze stolen USDT on Tron and Ethereum at law enforcement request

Fund your new wallet

Buy USDT on an established, identity-verified exchange and withdraw it to the wallet address you just created. Start with a small test transfer.

Operating since 2013 and registered with FinCEN (US) and the FCA (UK); readers in Asia are served by its international entity. Check availability and local rules in your country.

Get USDT for your wallet External link to a third-party exchange. We are an independent guide and receive no instructions from it.

Why we built this tool

In our research for every local section of this site, the same problem came up in each market: people losing money to wrong networks, poisoned addresses and fake "USDT received" screenshots. A five-second format check catches only the first of those, but it's the one that happens to careful people on a busy day. Pair it with the habits above and the network guide, and most avoidable losses disappear.

The checker runs entirely in your browser. It doesn't store addresses, doesn't call any API, and works offline once the page has loaded.

Questions people ask

How do I know if a USDT address is TRC20 or ERC20?

TRC20 (Tron) addresses start with a capital T and are 34 characters long. ERC20 addresses start with 0x followed by 40 hexadecimal characters. The same 0x format is used on BNB Chain, Polygon, Arbitrum and Avalanche, so for 0x addresses you must ask the receiver which network they expect.

Does a valid address mean it's safe to send?

No. A valid format only means the address is well-formed. It doesn't prove the address belongs to the person you think, that the receiver supports that network, or that it isn't a scam. Always confirm with the recipient and send a small test amount first.

What is address poisoning?

Scammers send tiny transfers from addresses that look like yours or your friend's, with matching first and last characters, hoping you'll copy the fake one from your history. Always copy addresses from the original source, not from your transaction list, and compare the full string.

Can I recover USDT sent to the wrong network?

Sometimes. If you sent to an exchange deposit address on an unsupported network, the exchange may be able to recover it, often for a fee, but it is not guaranteed. If you sent to a self-custody wallet that uses the same private key on both networks (for example EVM chains), the owner can usually access it. Funds sent to a mistyped address are almost always lost.

Does this tool send my address anywhere?

No. The check runs entirely in your browser using standard format rules and checksums. Nothing is sent to our servers. Only if you click the explorer link does your browser open that third-party website.

Fund your new wallet

Buy USDT on an established, identity-verified exchange and withdraw it to the wallet address you just created. Start with a small test transfer.

Operating since 2013 and registered with FinCEN (US) and the FCA (UK); readers in Asia are served by its international entity. Check availability and local rules in your country.

Get USDT for your wallet External link to a third-party exchange. We are an independent guide and receive no instructions from it.

Keep exploring